Advertisement
LINE VOLTAGE SELECT SWITCH
18
This selector switch allows the amplifier to be operated at different line voltages. Please be sure this switch is set to the
proper voltage for your area before connecting the amplifier to a power source or turning the amplifier on for the first time.
NEVER CHANGE THE POSITION OF THIS SWITCH WHILE THE AMPLIFIER IS TURNED ON.
CAUTION! THE FUSE MUST BE CHANGED TO THE CORRECT VALUE PRINTED ON THE REAR OF THE CHASSIS IF
A DIFFERENT LINE VOLTAGE IS SELECTED.
SPEAKER OUTPUT JACKS
19
These combination 1/4" / twist-lock connectors are used to connect speaker cables to the amplifier. The minimum load
impedance on the amplifier is 4Ω, which means that either a single 4Ω cabinet, or two 8Ω cabinets may be used.
FX LOOP
20
The effects loop consists of the SEND and RETURN jacks, which are used to patch external effects processors post EQ
in the signal chain. Connect the SEND jack to the input of effects processors. Connect the RETURN jack to the output of
effects processors.
DI PRE/POST SELECT SWITCH
21
This switch is used to select the DI signal source from either pre or post EQ. Usually, if the DI is used in a live setting to
send signal to a PA system, it's best to use the PRE EQ setting because the DI signal will not be effected by changing any
of the amplifier controls, which allows independent EQ adjustments for the PA system. The POST EQ setting is useful for
recording, connecting the amplifier to an external power amplifier, or for live use if you run effects processors through the
FX LOOP.
XLR BALANCED DI OUTPUT
22
This XLR output is used to connect the Mini Max pre amp section to external equipment, such as mixing consoles, external
power amplifiers, or recording equipment.
DI GND LIFT SWITCH
23
This switch may be used to eliminate hum caused by ground loops between the amplifier and other equipment, such as a
mixing console.
Advertisement
