Aux Input - Peavey Mini MAX Operating Manual

TUNE/MUTE

Pressing this button will engage the chromatic tuner while muting the output to the speaker. The LED screen will indicate

which note is being played while the red and green LEDs above the screen indicate whether the note is flat (red), sharp

(red) or in tune (green). This switch also mutes the DI.

AUX INPUT

This 1/8" input jack allows you to connect a CD player or MP3 player to your MAX Series bass amp

and play along

HEADHPHONE OUTPUT

1/8" headphone output for personal monitoring.

POWER SWITCH/DDT

This dual-purpose switch is used to turn the amp on and off. When the DDT (Distortion Detection Technique) senses

power amp clipping, a protection circuit is engaged and the LEDs in the power switch change to red.

CAUTION: The on/off switch in this unit does not break both sides of the primary mains. Hazardous energy can be present

inside the chassis even when the on/off switch is in the OFF position.

Rear Panel

AC POWER INLET

This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this connector to

provide power to the unit. Damage to the equipment may result if improper line voltage is used. (See line voltage marking

on unit).

Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground

pin, a suitable grounding adapter should be used, and the third wire should be grounded properly. To prevent the risk of

shock or fire hazard, always make sure that the amplifier and all associated equipment is properly grounded.

NOTE: FOR UK ONLY

As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying

the terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be connected to the

terminal that is marked by the letter E, or by the Earth symbol, or colored green or green and yellow. (2) The wire that is

colored blue must be connected to the terminal that is marked with the letter N, or the color black. (3) The wire that is

colored brown must be connected to the terminal that is marked with the letter L, or the color red.

FUSE

The fuse is located within the cap of the fuse holder. If the fuse should fail, IT MUST BE REPLACED WITH THE SAME TYPE

AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY. If the amp

repeatedly blows fuses, it should be taken to a factory authorized service center for repair.

WARNING! NEVER ATTEMPT TO REMOVE THE FUSE CAP OR REPLACE THE FUSE UNLESS THE POWER CORD HAS BEEN

DISCONNECTED FROM THE POWER OUTLET.

™

INDICATOR LIGHT