Cleaning The Nozzle - Bissell PROHEAT 2X REVOLUTION 1548 Series User Manual

Maintenance:
WARNING
To reduce the risk of electric shock, turn power switch off and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
1
First, fill the clean water
tank with warm tap water
and then empty it all to
rinse. Then fill again with
warm tap water and return
the tank to the machine.
Twist cap back on tightly.
Maintenance:
1
If pet hair or debris
become clogged in
the nozzle, it can be
cleaned out of the
nozzle with the nozzle
clean out tool.
Turn off and unplug
the machine from the
grounded outlet.
3
Hold the nozzle and insert the nozzle clean
out tool into the thin slot, on the end of
the nozzle that touches the floor. Clean
until free of pet hair or debris.
Cleaning Machine After Use
To flush and rinse the
machine: Turn the machine
on and press the trigger for
15 seconds while making
back and forth passes on
a section of carpet.
Finally, release the trigger
and suck up the water.

Cleaning the Nozzle

Remove the nozzle from the foot: flip the
accessory hose door open and lift up on
the nozzle and accessory hose door.
4
Return the nozzle back
to the foot of the
machine. Line up the
three hooks on the
nozzle to the bottom of
the foot. (see arrows for location)
Rotate the nozzle up and click into place.
Close the accessory hose door.
See page 14 to clean the
dirty tank from the water
that was just sucked up.
Empty the clean water tank
and let dry before storing.
Wipe your machine's
exterior with a soft cloth.
2
www.BISSELL.com
15