To Enter The Vehicle After Remote Start; To Exit Remote Start Mode And Drive The Vehicle; Cancel Remote Start - Dodge 2016 Grand Caravan Owner's Manual

• The engine can be started two consecutive 15-minute
cycles with the RKE transmitter. However, the ignition
switch must be turned to the ON/RUN position.

To Enter The Vehicle After Remote Start

To enter the vehicle while the engine is running during a
Remote Start, you must first unlock the vehicle using the
UNLOCK button on the transmitter. After the vehicle is
unlocked, you can enter the vehicle, insert the Key Fob
into the ignition switch, and turn it to the ON/RUN
position. Otherwise, the engine will shut off at the end of
15-minute cycle.

To Exit Remote Start Mode And Drive The Vehicle

Before the end of the 15-minute cycle, push and release
the UNLOCK button on the RKE transmitter to unlock
the doors and disarm the Vehicle Security Alarm (if
equipped). Then, prior to the end of the 15-minute cycle,
insert the Key Fob into the ignition switch and turn the
switch to the ON/RUN position.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 33
NOTE:
• The ignition switch must be in the ON/RUN position
in order to drive the vehicle.
• The message "Remote Start Active — Key To Run" will
display in the EVIC until you insert and turn the key to
ON/RUN position. Refer to "Electronic Vehicle Infor-
mation Center (EVIC) in Understanding Your Instru-
ment Panel" for further information.

Cancel Remote Start

Remote Starting will also cancel if any of the following
occur:
• The engine stalls or engine speed exceeds 2500 rpm.
• Any engine warning lights come on.
• Low Fuel Light turns on.
• The hood is opened.
2