Tightening Torque; Other, General Tightening Torques; Lubricants, Areas To Apply Sealant And Specified Types - Yamaha X94 Series Service Manual

Lubricants, areas to apply sealant and specified types

Tightening Torque

Drive sprocket lock nut
Stator cover installation
Motor assembly and bearing housing
Circuit board installation
Holder installation
LCD type display holder
ISIS adapter installation

Other, general tightening torques

The tightening torques of bolts and nuts other than those with tightening force for specified locations
is determined by the screw diameter (width between two surfaces) and the pitch.
4
Lubricants, areas to apply sealant and specified types
Where to apply
All oil seal lips
Pawl kicks
Drive axle O-rings
Interior of torque sensor bushing
Spline of torque sensor
Interiors of the drive axle assembly
and the one-way inner/outer bosses
All driven gear surfaces
Motor assembly's surface which con-
tact to the gromet of power lead wire.
Mating surfaces between motor
assembly and bearing housing
Tightening locations
Width between surfaces
Screw diameter
Pitch
Tightening Torque/
Service Data
Screw
Q'ty
diameter
M27 1
M5 3
M5 6
M3 5
M3 2
M3 2
M8 2
Screw diameter (width
between two surfaces)
pitch
×
M4 (7 mm)
×
M5 (8 mm)
M6 (10 mm)
M8 (12 mm)
Types of oils, grease, and sealants
Lithium grease made from synthetic hydrocarbon oil and
synthetic ester oil (MULTEMP AC-N
Lithium grease made from synthetic hydrocarbon oil and
synthetic ester oil (MULTEMP AC-N
Lithium-soap-based grease
Lithium grease made from synthetic hydrocarbon oil and
synthetic ester oil (MULTEMP AC-N
Lithium grease made from synthetic hydrocarbon oil and
synthetic ester oil (MULTEMP AC-N
Lithium grease made from synthetic hydrocarbon oil and
synthetic ester oil (MULTEMP AC-N
Lithium grease made from synthetic hydrocarbon oil and
synthetic ester oil (MULTEMP AC-N
Lithium-soap-based grease
®
Three Bond 1215
4-1
Service
Data
Unit: Nm kgf·m (in)
Tightening
torque
40 (4.0) Left hand screw
4.5 (0.45)
4.5 (0.45)
1.3 (0.13) Self-tapping screw
0.75 (0.075) Self-tapping screw
0.3 (0.03)
25.5 (2.55) Torx T30
×
Tightening torque
1.5 to 2.5 Nm
P0.7
(0.15 to 0.25 kgf·m)
3 to 4.5 Nm
P0.8
(0.3 to 0.45 kgf·m)
5 to 8 Nm
×
P1.0
(0.5 to 0.8 kgf·m)
12 to 19 Nm
×
P1.25
(1.2 to 1.9 kgf·m)
®
)
®
)
®
)
®
)
®
)
®
)
Notes