Installation Of The Stator Cover - Yamaha X94 Series Service Manual

sealant
1
2
2
Drive axle, Motor

Installation of the Stator Cover

1. Apply Three Bond 1215
TIP
TIP
• Before applying the sealant, thoroughly
• Within 5 min. after applying the sealant, join
2. Install the following part:
1
New
TIP
TIP
• When assembling the stator cover, hand
• Install the Damper rubber 1 inside the stator
• Be sure to replace the Damper rubber 1
3-14
parts:
• Motor complete 1
Apply a continuous 2 to 3 mm thick coating
as shown in the drawing (area indicated by
dark line).
Three Bond 1215
clean all the mating surface of stator cover
and motor complete.
the left and right halves together.
• Damper rubber 1
• Stator cover 2
tighten the three flanged bolts and then
tighten them evenly.
cover.
with a new one when the assembly is disas-
sembled.
Drive
Unit
®
to the following
®
4.5 Nm (0.45 kgf·m)