Memory Channels - Cobra MR F77W GPS Owner's Manual

Advanced Operation
Operating Your Radio

Memory Channels

You can program (or tag) any or all channels to be scanned in the Memory
Scan mode.
To Program Memory Channels:
Standby Mode
1. From Standby mode, select a channel to be tagged using
the Up/Down buttons.
2. Press the MORE soft key (if necessary), then the MEM
soft key. The channel will be tagged for scanning and
MEM (memory channel) will appear on the LCD whenever
Up/Down Buttons
that channel is selected.
Repeat steps 1 through 2 to add addition memory
channels.
To Clear Memory Channels:
Soft Keys
1. From Standby mode, select a channel to be cleared
from a memory tagging using the Up/Down buttons.
2. Press and hold the MORE soft key (if necessary), then
the MEM soft key. The channel will be untagged and
MEM (memory channel) will no longer appear on the LCD
USA 25W
07:30 11/15 whenever that channel is selected.
o
25 53.438N
o
110 27.843W comml Repeat steps 1 through 2 to clear additional channels
TW WX call more
from memory locations.
USA 25W MEM
Memory Scan
07:30 11/15
o
25 53.438N
o
110 27.843W comml
During Memory Scan, the radio will rapidly switch from
TW WX call more
tagged channel to tagged channel. Whenever any activity is
detected, the radio will stop the scan to allow you to listen
Scanning
to the activity on that channel. The radio will then continue
to scan after 2 seconds of inactivity, unless you switch out of
the Memory Scan mode.
88 30 88
75 60
14
88
46 English
79
15
30
75 60
68
69
71
A
72
Advanced Operation
Operating Your Radio
NOTE
If there are fewer than two (2) channels tagged,
the Memory Scan mode will not be available.
[See page 47 under program memory channels
to tag at least two (2) channels.]
NOTE
The radio must be squelched for the Memory Scan mode
to function. See page 26 for squelch procedure.
To Enter Memory Scan:
Standby Mode
1. From Standby mode, press the MORE soft key (if
necessary), then the SCAN soft key.
The radio will immediately begin to scan the channels you
tagged. SCAN (memory scan) will be highlighted on the LCD.
Soft Keys
To Exit Memory Scan:
1. From Memory Scan mode, press the SCAN soft key.
This will return the radio to Standby mode on the last
scanned memory location.
During Memory Scan (while receiving an incoming
transmission), You Can Choose From The Following:
USA 25W mem
07:30 11/15
a. Press the Talk button to remain on that memory
o
25 53.438N
o
110 27.843W comml
location and end scanning. This will return the radio
TW WX SCAN more
to Standby mode.
The radio will then continue to scan after 2 seconds of
inactivity, unless you switch out of the Memory Scan
mode.
During Memory Scan (while not receiving a
transmission):
b. Press the Talk button to communicate on the last
channel scanned and return to Standby mode.
Nothing Comes Close to a Cobra 47
®