Table of Contents
Advertisement
M
aintenance and care
Brush removal and
replacement
1. Turn Off (0) the machine and unplug
from the outlet.
2. Remove the dirty and clean water tanks
from the base of the machine.
3. While standing behind the unit, lay the
unit on its side (cord side down).
4. looking at the bottom of the unit, find the
center of the brush carriage where the
carriage latch is located. It is between
the brush assembly and wheels.
5. Pull the brush carriage towards you with
one hand until it stops. Pinch the car-
riage latch with the other hand while
pulling the carriage towards you. The
carriage should swing out to access
brush end cover.
6. Remove three screws from endcap. Pull
endcap off to release brush roll.
7. With cover removed, the brush comes
out easily by tilting the loose end out of
the carriage.
8. To replace the brush roll back into the
unit, place the large open end of the
brush onto the carriage and tilt opposite
end back into place.
9. With the brush sitting relatively straight
up and down by itself, place endcap
back on top and replace three screws.
The brush will need to be held and
centered to the cover while placing it
back on.
10. spin the brush by hand to make sure it
turns freely with some minor resistance
from the motor. Push brush carriage
back into place with a light pull against
the lock.
14
www.bissell.com
WARNING:
To reduce the risk of fire, electric
shock, or injury, turn power
Off and disconnect plug from
electrical outlet before performing
maintenance or troubleshooting.
3.
4.
6A.
7.
9.
5.
6B.
8.
10.
Advertisement
Table of Contents
