Dodge 2015 GRAND CARAVAN User Manual page 75

3. Push and hold the HomeLink
the hand-held transmitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink
indicator will flash slowly and then rapidly after HomeLink
quency signal from the hand-held transmitter. Release both buttons after the indicator
light changes from slow to rapid.
5. At the garage door opener motor (in the garage), locate the "LEARN" or "TRAINING"
button. This can usually be found where the hanging antenna wire is attached to the
garage door opener motor. Firmly push and release the "LEARN" or "TRAINING" button.
NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has been
pushed.
6. Return to the vehicle and push the programmed HomeLink
button for two seconds each time). If the device is plugged in and activates,
programming is complete.
NOTE:
If the device does not activate, push the button a third time (for two seconds) to complete
the training.
7. To program the remaining two HomeLink
remaining button. DO NOT erase the channels.
Programming A Non-Rolling Code
NOTE:
For programming Garage Door Openers manufactured before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
3. Push and hold the HomeLink
the hand-held transmitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink
indicator will flash slowly and then rapidly after HomeLink
quency signal from the hand-held transmitter. Release both buttons after the indicator
light changes from slow to rapid.
5. Push and hold the programmed HomeLink
If the indicator light stays on constantly, programming is complete and the garage door
(or device) should activate when the HomeLink
6. To program the two remaining HomeLink
remaining button. DO NOT erase the channels.
E L E C T R O N I C S
® button you want to program while you push and hold
® buttons, repeat each step for each
® button you want to program while you push and hold
® button and observe the indicator light.
®
® buttons, repeat each step for each
has received the fre-
®
® button twice (holding the
indicator light in view.
®
® has received the fre-
button is pushed.
®
®
®
73