To Use Your Blender; Key To The Illustration - Kenwood BLP60 Instruction Manual

G
This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
Use your blender for soups, drinks,
pâtés, mayonnaise, breadcrumbs,
biscuit crumbs, chopping nuts and
crushing ice. Use your multi mill (if
supplied) for milling herbs, nuts,
coffee beans and purées.
key
filler cap
lid
vents
goblet
sealing ring
blade unit
blade base
power unit
Power On indicator
speed + pulse control
TYPE BLM61 & BLP61 only
Programme buttons
drinks
ice crush
rinse
Multi mill (if supplied)
multi mill jar
grinding mill (if supplied)
mill lid
grinding mill blade assembly
grating mill (if supplied)
mill lid
grating mill blade assembly

to use your blender

1 Fit the sealing ring
unit - ensuring the seal is located
correctly in the grooved area.
G
Leaking will occur if the seal
is damaged or incorrectly
fitted.
2 Clip the blade unit
.
3 Screw the blade assembly onto the
goblet – ensuring the blade
assembly is fully tightened
to the graphics on the underside of
the blade unit as follows:
- unlocked position
- locked position
4 Put your ingredients into the goblet.
5 Fit the filler cap to the lid and push
down to secure.
6 Fit the lid by pushing down until
secure.
7 Place the blender onto the power
unit .
G
The appliance will not work if
the blender is incorrectly
fitted.
8 Plug in and the indicator light will
remain unlit whilst in the "O" OFF
position.
TYPE BLM60 & BLP60 - Turn
the speed control to select a speed
(refer to the recommended usage
chart).
G
Select a speed between 'Min' to
'Max' by turning the speed control.
At the end of blending return the
speed control to "O" OFF before
removing the blender.
G
Do not remove the goblet until the
blades have stopped rotating and
the speed control is in the "O" OFF
position.
G
(P) Pulse – operates the motor in a
start/stop action. The pulse will
operate for as long as it is held in
position.
Note: If the blender is removed from
the power unit whilst a speed is
selected the Indicator light will go
out and the blender will stop. The
blender willl restart immediately if
refitted.
6
into the blade
into the base
. Refer