Troubleshooting Guide - Kenwood BLP60 Instruction Manual

troubleshooting guide

Problem
The Blender will not
operate.
Power On Light flashing
slowly.
(BLP61/BLM61 only)
BLP61/BLM61 Blender not Goblet fitted and speed control Either select a speed
operating but Power On
and programme button
lights on.
Power on light flashing
rapidly (BLP61/BLM61 only) the power unit without turning control to "O" OFF
Programme buttons not
operating
Blender leaking from blade Seal missing.
assembly.
Blender seal missing from
blade unit when removed
from packaging.
If none of the above solve the problem see "Service & Customer Care".
Cause
No Power/Power On
Light not illuminated.
Blender not assembled
correctly.
The blender has been left
plugged in and in the 'on'
position for more than 15
minutes and has gone into
standby mode.
turned to "on" but speed or
programme not selected.
The goblet is removed from
the speed control to "O" OFF. and reselected a
Programme buttons will
not operate unless the speed control to "on" and
control is turned to the "on"
position first.
Seal incorrectly fitted.
Seal damaged.
The seal is packed pre-fitted
to the blade unit.
12
Solution
Check blender
plugged in.
Check blade unit is
fully tightened to
the goblet.
Turn the speed
control to the
"O" OFF position,
wait 5 seconds and
then turn to "on" to
reset.
manually or press
one of the
programme buttons.
Turn the speed
speed.
Turn the speed
select the required
programme.
Check seal is fitted
correctly and not
damaged. To obtain
a replacement seal
see "service &
customer care".
Unscrew goblet and
check that seal is
fitted to blade unit.
To obtain a
replacement seal
see "service &
customer care".