Denon DHT-1312XP Service Manual page 87

Temp Rating
Part Number
EX3AV -40 to +85

EX3AV (HDMI : IC16)

Figure 3: Pinout Diagram (Top View)
EX3AV Terminal Functions
NOTE: All perimeter pins must be soldered to PCB.
PIN NAME
1-2, 12,
26, 34- NC(SW)
38
3-4,
NC
FUNCTION
22-25
5-11 VOUT
13-18 PGND
19-21 PVIN
27 ENABLE
28 POK
29 EAOUT
30 SS
31 XFB
32 AGND
33 AVIN
Enpirion 2009 all rights reserved, E&OE
2
EX3AV
(° C) Package
38-pin QFN T&R
NO CONNECT – These pins are internally connected to the common switching node of the
internal MOSFETs. They are not to be electrically connected to any external signal, ground,
or voltage. Failure to follow this guideline may result in damage to the device.
NO CONNECT – These pins may be internally connected. Do not connect them to each
other or to any other electrical signal. Failure to follow this guideline may result in device
damage.
Regulated converter output. Connect these pins to the load, and place output capacitor
from these pins and PGND pins 13-15
Input/Output power ground. Connect these pins to the ground electrode of the Input and
output filter capacitors. See VOUT and PVIN pin descriptions for more details.
Input power supply. Connect to input power supply. Decouple with input capacitor to
PGND pins 16-18.
Input Enable. Applying logic high enables the output and initiates a soft-start. Applying a
logic low disables the output.
Power OK is an open drain transistor for power system state indication. POK will be logic
high when VOUT is with -10% to +20% of VOUT nominal.
Optional Error Amplifier output. Allows for customization of the control loop response.
Soft-Start node. The soft-start capacitor is connected between this pin and AGND. The
value of this capacitor determines the startup time.
External Feedback Input. The feedback loop is closed through this pin. A voltage divider at
VOUT is used to set the output voltage. The mid point of the divider is connected to XFB. A
phase lead capacitor from this pin to VOUT is also required to stabilize the loop.
Analog Ground. This is the Ground return for the controller. Needs to be connected to a
quiet ground.
Input power supply for the controller. Needs to be connected to input voltage at a quiet
point.
www.enpirion.com
Figure 3: Pinout Diagram (Top View)
NOTE: All perimeter pins must be soldered to PCB.
FUNCTION
2
87
www.enpirion.com