Interior Light; Automatic Defrost; Care And Maintenance; Cleaning Your Appliance - Magic Chef MCWBC77DZC Instruction Manual

Note:
The temperature display can be changed between Celsius and Fahrenheit by pressing and
holding both pads
seconds, provided the pads are unlocked and no any other setting operation is in process
(Display does not flash).

Interior Light

You can press the pad
and no any other setting operation is in process (Display does not flash).

AUTOMATIC DEFROST

There is no need for manual defrosting of this appliance due to automatic defrosting function.
•
The ice build-up on the inner back wall during compressor operation will be automatically
defrosted in a compressor off cycle.
•
When defrosting is in process, the indicators
for both zones will run.
•
Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan
located above the compressor, from where it evaporates.

CARE AND MAINTENANCE

Cleaning Your Appliance

•
Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.
•
Turn off the appliance first and then unplug the unit from the wall outlet.
•
Remove all contents.
•
Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda solution.
The solution should be about 2 tablespoons of baking soda to a quart of water.
•
Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.
•
The outside of the appliance should be cleaned with mild detergent and warm water.
•
Dry the interior and exterior with a soft cloth.
•
Dust or anything else blocking the vent may hinder the cooling efficiency of the appliance.
Vacuum the vent if necessary.

Vacation Time

•
Turn off the appliance first and then unplug the unit from the wall outlet.
•
Remove all the contents.
•
Clean the appliance.
•
Leave the door open slightly to avoid possible formation of condensation, mold, or odors.
•
Short vacations: Leave the appliance operating during vacations of less than three weeks.
•
Long vacations: If the appliance will not be used for several months, remove all content and
unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth,
leave the door open slightly: blocking it open if necessary.

Moving Your Appliance

•
Turn off the appliance first and then unplug the unit from the wall outlet.
•
Remove all the contents.
•
Securely tape down all loose items inside your appliance.
•
Tape the doors shut.

Energy Saving Tips

•
The appliance should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
•
Ensure that door is closed when the appliance is turned on.
(warmer) and (colder) for the upper zone for approximately 3
(light) to switch the interior light on/off, provided the pads are unlocked
7
for both zones will go off, and the circulation fans
EN