Removing the module holder
► Open the casing (see
► Disconnect the cables connected to the module holder.
► Remove the screws (1) on the module holder.
► Push the module holder out of the casing in the direction of the arrow (2).
Screwing the WLAN module onto the module holder
2
a
Fujitsu
"Opening the casing", Page
2
a
1
37).
1 1
2
► Push the WLAN module - with the
component side facing downwards - in
the direction of the arrow (1) into the
guide on the module holder (a).
► Fasten the WLAN module with the
screws (2).
System expansions
43