To Adjust The Shock Sensor Full Trigger; To Test And Adjust The Current Full Trigger Setting - Wasp 718W Installation Manual

To adjust the shock sensor full trigger:

2. Within five seconds press and hold
3. Release

To test and adjust the current full trigger setting:

Strike the vehicle to test the current setting. If the impact is detected the unit will chirp three or four times. If the
current setting is acceptable do nothing and the unit will exit shock sensor adjustment mode. If the current setting
is unacceptable press Button I to decrease the sensitivity or Button II to increase the sensitivity. Each time Button
I is pressed the unit will emit one chirp and the sensitivity is decreased one step. Each time Button II is pressed
the unit will emit two chirps and the sensitivity will be increased one step. There are 16 possible settings. When the
maximum or minimum setting is achieved the siren will emit a long chirp.
NOTE: If more than five seconds elapse without an adjustment, shock sensor adjustment mode is
exited. Repeat steps 1 through 3 to make additional adjustments.
The siren will generate one long chirp followed by two short chirps when the shock sensor adjustment mode is
exited.
© 1999 Directed Electronics, Inc.
1. Arm the system by pressing
long chirp.
on the transmitter.
.
on the transmitter until the unit generates a
7 N718W 7/99