Wire Connection Guide; Transmitter/Receiver Learn Routine; To Enter The Transmitter/Receiver Learn Routine - Wasp 718W Installation Manual

BLUE/WHITE 2V (-) LED output: Connect this wire to the blue wire of the supplied LED. Connect the RED wire of
the LED to a fused source of (+)12V.
BLACK (-) chassis ground input: Connect this wire to bare metal, preferably with a factory bolt rather than your
own screw (screws tend to either strip or loosen with time).
RED (+)12V constant power input: Before connecting this wire, remove the supplied fuse. Connect to the battery's
positive terminal or to the (+)12V feed to the dome light circuit.
NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 10A fuse
in the harness for this purpose. This fuse protects the module itself.
This system uses a microprocessor-based Learn Routine
transmitters are retained in memory, even if the security system is disconnected from the vehicle battery.

To enter the Transmitter/Receiver Learn Routine:

The Transmitter Learn Routine
mitter code. The system will generate one short chirp followed by a long chirp when the Learn Routine
© 1999 Directed Electronics, Inc.

WIRE CONNECTION GUIDE

TRANSMITTER/RECEIVER LEARN ROUTINE™

1. Power the system up. If the system is already powered up, it must be powered down
before it will enter the Transmitter/Receiver Learn Routine
2. Within 5 seconds press
3. Within 5 seconds press
4. Within 5 seconds press
ate one long chirp.
5. Repeat Steps 2 through 4 for all transmitters that need to be learned. The system can
learn up to four transmitters.
™ will automatically be exited if 5 seconds elapse without the unit receiving a trans-
™ to learn and store transmitters in memory. Up to four
on the first transmitter. The siren will chirp once.
on the first transmitter AGAIN. The siren will chirp twice.
on the first transmitter a THIRD time. The unit will gener-
4
™ .
™ is exited.
N718W 7/99