Operation Settings Learn Routine; To Enter The Operation Settings Learn Routine - Wasp 718W Installation Manual

Many of the system features are programmable. The Operation Settings Learn Routine
gram the system features. You must program the transmitter before programming the system features.

To enter the Operation Settings Learn Routine:

1. Arm the system by pressing
2. Disarm the system by pressing
3. Press and hold both buttons on the transmitter until the unit generates a long chirp.
4. Release the transmitter buttons.
Repeat steps 3 and 4 to advance to the next feature. Each time you advance a feature, the short siren chirps will
indicate which feature number you have accessed.
Feature
Number Feature
1 Current Sense
2 Current Sense Delay
3 Audible Arm/Disarm Confirmation
4 Code Hopping
5. Program the selected feature. Pressing Button I on the transmitter will select the one-
or
After programming a feature, another feature can be selected by repeating steps 3 and 4. The Learn Routine
be exited if 5 seconds elapse between steps. The system will exit Learn Routine
ture has been selected. When the Operation Settings Learn Routine
a long chirp.
© 1999 Directed Electronics, Inc.

OPERATION SETTINGS LEARN ROUTINE™

The long chirp is followed by a short chirp indicating that you have accessed Feature
Number 1 in the Operation Settings Learn Routine
™
chirp setting and the siren will chirp once. Pressing Button II on the transmitter will
select the two-chirp setting and the siren will chirp twice. The default settings are the
one-chirp settings except where indicated by bold text.
.
again.
™ .
One-Chirp
Setting
On
5 seconds
On
On
™ immediately after the last fea-
™ is exited, the unit will chirp once followed by
5
™ is used to access and pro-
Two-Chirp
Setting
Off
5 minutes
Off
Off
™ will
N718W 7/99