Advertisement
Removing Old FW Heater
1. Pull off thermostat knob (if applicable) and remove top and bottom grill
screws to remove grill.
2. Remove screw on bottom center of heater assembly.
3. Unscrew insulated wire connectors and separate supply wires from
heater wires.
4. Remove the heater assembly by pushing up in the direction of the fan
and pulling unit out of wall can.
Installing Conversion Kit
1. Screw top and bottom screws and washers about halfway into the wall
can with the half-moon tabs facing out (See Figure 1).
2. Push plate down into position.
3. Tighten the screws. NOTE: Star washers MUST be located between
the screw head and painted surface of the conversion plate.
4. Install one spring nut at the top and one at the bottom (See Figure 2).
Installing New Heater Assembly
Note: If FW heater was wired with the supply circuit entering the wall can
from the top, it may be necessary to add 8 inches of lead wire to each of
the supply lines before proceeding with installation of new heater.
1. The Com-Pak requires a thermostat to operate. Please follow
wiring instructions supplied with either your built-in thermostat kit
or wall mount thermostat and your new heater. If new heater has
a built-in thermostat, the two mounting screws must be removed
and reattached to the bottom of the FWAP.
2. Once wiring is complete, slide heater assembly into half-moon tabs
located on bottom of conversion plate. Use screw supplied with heater
assembly and star washer supplied with kit to attach heater to
conversion plate.
3. If using original grill, turn the grill upside down (See Figure 3) and
install using two new #10 screws. If there is a built-in thermostat,
be sure it is at the bottom.
4. Affix new label (provided) on inverted grill. It is not necessary to
remove the old label. If using a built-in thermostat, cut thermostat
shaft hole out of new label.
Operation Instructions
1. Once installation is complete and power has been restored, turn the
thermostat knob fully clockwise.
2. When the room reaches your comfort level, turn the thermostat knob
counterclockwise until the heater turns off. The heater will
automatically cycle around this preset temperature.
3. To reduce the room temperature, turn the knob counterclockwise.
To increase the room temperature, turn the knob clockwise.
FWAP Instructions (Back Side)
Figure 2
Spring Nut
Spring Nut
Figure 3
©2014 Cadet
Printed in U.S.A.
Figure 1
half-
moon
tabs
12/14
#720027
Advertisement
