Motorola AirDefence Installation Manual page 16

10 Server Appliance Installation Guide
Alternative A: Specify the time zone and time
1. Type
The Time zone screen displays a list of global regions.
2. Type the number that corresponds to your region name, and then press
A list of nations within the region displays.
3. Type the abbreviation of the nation in which the AirDefense Server resides, and then
press
A list of regions within the nation displays.
4. Type the number of the region in which the AirDefense Server resides, and then press
Enter
5. Type
6. Type
The CLI displays the current settings for date and time.
7. Type the date in MMDDYYYY format, and then press
forward slashes.
8. Type the time in 24-hour HHMM or HHMMSS format, and then press
9. Type
The Config screen displays. Do not exit WIPSadmin. This will cause the system to
reboot.
10. Go to Step 5: Configure the IP Address.
Alternative B: Specify an NTP Server
1. Type ntp at the prompt, and then press <Enter>.
The NTP screen displays, indicating whether NTP is currently enabled.
2. Type e to enable NTP, and then press <Enter>.
3. Type the IP address or Fully Qualified Domain Name of the NTP server you want this
appliance to use, and then press <Enter>.
4. Type yes to save your changes, and then press <Enter>.
Do not exit from WIPSadmin. This will cause the system to reboot.
5. Go to the next step: Configure the IP Address.
at the prompt, and then press
tz
.
Enter
.
to save your changes, and then press
yes
at the prompt, and then press
time
to save your changes, and then press
yes
.
Enter
.
Enter
.
Enter
. Do not use colons or
Enter
.
Enter
.
Enter
.
Enter