Table of Contents
Advertisement
4
Server Appliance Installation Guide
Sensor Information
• Assign an IP address, subnet mask, and default gateway to each Sensor.
2.2 Overview
Getting started with AirDefense Enterprise Server is an eight step process. Each step is described in
this book.
1. Install the AirDefense Server appliance.
2. Power up the appliance.
3. Launch the Command Line Interface. (WIPSadmin)
4. Configure time settings. (TZ and Time)
5. Configure the IP address. (IP)
6. Create a user with admin privileges. (WEBU)
7. Install the application and log into the appliance GUI.
8. Use the System Setup Wizard for initial configuration.
2.3 Cautionary Statements
CAUTION
CAUTION
CAUTION
CAUTION
AirDefense highly recommends that you change all passwords at your
earliest opportunity.
There are no user-serviceable components inside the AirDefense
Server. Opening the chassis will void the warranty.
The recommended ambient operating temperature of the AirDefense
Server appliance is 10ºC - 35ºC (50ºF - 95ºF). Installation in a closed or
multi-rack assembly may raise the immediate ambient temperature
above the average room temperature. Exercise due caution.
Provide adequate spacing above, below, and behind the AirDefense
Server, to allow proper air flow, and to prevent excessive heat buildup.
Advertisement
Table of Contents
