Problem Solving Guide; Messages In The Display - Miele TKG 450 WP Operating Instructions Manual

Problem solving guide

With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting Miele.
Please note that a call-out charge will be applied to service visits where the
problem could have been rectified as described in these operating instructions.

Repair work to electrical appliances should only be carried out by an
authorised Miele service technician. Repairs and other work by unqualified
persons could be dangerous. Miele cannot be held liable for unauthorised
work.
Some of the messages in the display are more than one line long. Touch the  or
 sensor to read them in full.

Messages in the display

Problem
 lights up after
switching on

Adjust load See 
lights up after a
programme is cancelled

Call service  Fault F
lights up after a
programme is cancelled
Possible cause and remedy
Access via a code has been activated.
 See "Settings menu - PIN Code".
This is not a fault.
In some programmes, if the drum has been
underloaded or is empty, the programme will be
cancelled. This can also happen if the items are
already dry.
 Open and close the door to resume drying.
 Use the Warm air programme (timed drying) to dry
individual items.
There is no obvious cause.
 Switch the dryer off and then on again.
 Start a programme.
If the programme is cancelled again and an error
message appears, there is a fault. Contact Miele.
Problem solving guide
51