Setting Tone Options; Viewing Technical Gps Information; Setting The Gps Position - Magellan MAESTRO 3100 User Manual

Tap Stop to end simulating the current route you are simulating.
(The Simulate button is presently not active.)
4. Tap Back arrow to record the changes and exit.

Setting Tone Options

Provides a way of selecting the tone used to announce arrival at a maneuver or destination.
1. From page 2 of the Main Menu, tap User Options.
2. Tap Tone Options.
3. Select Bell, Chime or Beep.
4. Tap Save to record the changes and exit.

Viewing Technical GPS Information

This screen provides technical information about the satellites being used to compute the GPS
position.
1. From page 2 of the Main Menu, tap User Options.
2. Tap GPS Options.
3. Tap GPS Status.
PRN: pseudo random number that
identifies the satellite
AZ: Azimuth of the satellite
EL: Satellite elevation
SNR: Satellite signal-to-noise ratio
TTFF: Time to First Fix (in seconds)
4. Tap Back arrow to exit.

Setting the GPS Position

Setting a GPS position is useful if you are not getting satellite information quickly because the
Magellan Maestro has travelled over 500 miles while turned off. Setting the GPS position will allow
the Magellan Maestro to compute which satellites are available and calculate the position quicker.
1. From page 2 of the Main Menu, tap User Options.
2. Tap GPS Options.
3. Tap Set GPS Position.
4. Follow the prompts to enter the address where you currently are.
5. Tap Done when finished entering the address.
User Options 45