Opening And Closing The Processor Cage - HP Integrity rx2660 User's & Service Manual

a. Unfasten the processor installation tool (2.5 mm driver) from the tool holder on the
airflow guide.
b. Insert the processor tool into the hole on the side of the heatsink.
c. Rotate the processor tool counter-clockwise 180 degrees.
CAUTION:
turning the processor tool half of a full turn. The counter-clockwise 180 degree rotation
(half turn) unlocks the socket. A clockwise 180 degree rotation locks the socket.
Attempting to turn the locking mechanism more than 180 degrees can severely damage
the socket.
d. Refasten the processor install tool (2.5 mm driver) to the tool holder on the airflow
guide.
8. Remove the processor from the processor slot.
a. Carefully grasp the sheet metal that encases the processor.
b. Pull the processor straight up and out of the server.
9. Protect the processor from damage.
a. Install the protective pin cover on the processor connectors to shield the connector pins.
b. Place the processor in an anti-static container.
Figure 6-28 shows how to open the processor cage.
Figure 6-28 Opening and Closing the Processor Cage
Figure 6-29 shows the processor cage open.
178 Removing and Replacing Server Components
The processor zero insertion force (ZIF) socket is locked and unlocked by