Adjustment Of Components; Bevel Angle Adjustment; Packing - Hitachi C 12LCH Technical Data And Service Manual

9. ADJUSTMENT OF COMPONENTS

9-1. Bevel Angle Adjustment

Before the power tool is shipped from the factory, it is adjusted for 0û, left 45û bevel cutting angle with the
8 mm nylock bolt. When changing the adjustment, change the height of the 8 mm nylock bolt by turning them.
(The maximum bevel cutting angle is 48û).
NOTE: Do not adjust the 8 mm nylock bolt with plates (A) and (B) (Fig. 15-2) pulled.
Fig. 27-a

10. PACKING

(1) Preparation before packing
Turn the turn table 45û clockwise.
(2) Mounting packing (C)
Place packing (C) under the gear case and swing the motor section. Pressing on packing (C), hook the
stopper pin on the gear case.
(3) Mounting packing (E)
Fold packing (E) in two at the center and insert it between the gear case and protective cover (A).
(4) Mounting packings (B) and (A)
Place the base packing in the carton box and place the power tool on it. Fit packing (B) on the housing.
Place packing (A) at the left of the base.
(5) Mounting upper packing
Place the upper packing on packings (A) and (B). Close the carton box.
8 mm nylock bolt
(Stopper for 0û)
Indicator
(For bevel scale)
8 mm nylock bolt
(Stopper for left
45û bevel angle)
--- 22 ---
Fig. 27-b