I-5. Wps Setup; Iii-3 - Edimax EW-7438AC User Manual

I-5. WPS Setup

The WPS button is a quick and easy method to establish a secure connection
between your EW-7438AC and wireless router/access point.
If your wireless device supports WPS (Wi-Fi Protected Setup) then you can use
this method to setup your wireless extender in extender or adapter/bridge
mode, instead of the setup wizard described in
Please do not hold the WPS button for too long – this may reset
your device.
1.
Press the WPS button on your wireless
router/access point for the correct
length of time to activate its WPS.
Please check the instructions for
your wireless device for how long
you need to hold down its WPS
button to activate WPS.
2.
Within two minutes, press and hold
the WPS button on the wireless
extender for two seconds. The
extender's blue
to indicate that WPS is in progress.
3.
The devices will establish a connection.
The extender's
display on for 30 seconds to indicate a
successful connection.
The extender can establish either a 2.4GHz or 5GHz connection
using the WPS button. By default the extender will establish a
5GHz connection where available. Use iQ Setup to extend both
2.4GHz & 5GHz together.
WPS LED should flash
blue WPS LED should
II. Installation.
5