System Menu - Sony DXC-C33P Instructions For Use Manual

SYSTEM Menu

The SYSTEM menu is used to set the items
relating to the system of the camera and
selection of output signals.
<SYSTEM>
>BAUD RATE
D-SUB VIDEO
D-SUB SYNC
RGB SYNC
EXT SYNC
Select
MENU
BAUD RATE
Switches the baud rate of the
connector.
Sets to any of 19200, 9600, 4800, 2400
and 1200.
Set to 9600 when the RM-C950 remote
control unit is connected.
D-SUB VIDEO
Selects the VBS or Y/C signal output from
the RGB/SYNC connector (D-sub 9-
pin).
D-SUB SYNC
Selects the sync signal output from the
RGB/SYNC connector (D-sub 9-pin).
C. SYNC
Outputs the composite sync signal.
WEN-ODD/WEN-EVEN/WEN-NORM
Outputs the WEN signal. When connecting
peripheral equipment, the signal is used as
trigger pulse output to the equipment.
Switching WEN-ODD or WEN-EVEN
provides a different pulse signal phase.
26
SYSTEM Menu
[A]
9600
VBS
C.SYNC
G
IN
Back
REMOTE
For the timing chart of the WEN pulse signal
for each setting, see page 47.
POLARITY
Selects the polarity of the pulse signal.
: Negative
: Positive
RGB SYNC
Adds a sync signal to the G signal or R, G
and B signals output from the
SYNC connector.
OFF
No sync signal is added to an output signal.
G
Adds a sync signal to the G signal output
from the RGB/SYNC connector.
RGB
Adds sync signals to the G, B and R signals
output from the
connector.
EXT SYNC
Switches the input and output of the EXT
SYNC (HD, VD/SYNC) jacks (BNC type)
and selects the output signal.
IN
Functions as the input jack.
When an external sync signal (VBS signal)
is input, the following items appear:
Adjusts the horizontal phase and SC
(subcarrier) phase to synchronize the camera
operation with the reference signal.
H. PHASE
Adjusts the horizontal phase within the
range from –20 to +127.
RGB/
RGB/SYNC