Beko E1 CHASSIS Service Manual page 9

Use the Program down button to
select AUTOPROGRAM and press
the OK button.
Please Note:
a) On the TV sets equipped with ATS a
COUNTRY SELECTION menu will appear.
Select the desired country using Program and
Volume buttons.
Press the OK button to select the country and
press the OK button again the Automatic Tuning
System regarding the broadcasting system in
the desired country.
b) On the TV sets without ATS pressing the OK
button starts AUTOPROGRAM.
When you are sure the aerial is
connected properly press the OK
button and to confirm it press OK
button again.
To cancel Autoprogram whilst it is
working press the Menu button. As
Autoprogram stores a channel it will
appear briefly on the screen.
Your TV is now tuned and ready to use
E. TV SET UP
The TV set up is accessed through a menu
system.
Once you have stored your set up, this is the
set up the TV will default to when you switch it
on.
Please note
If you do not press any buttons for 18-19
seconds the TV will exit the menu system.
There are three menus;
• Picture Menu
• Setup Menu
• Features Menu
• Picture Menu
To reach the picture menu press one time
to MENU button.
BRIGHTNESS
CONTRAST
COLOUR
SHARPNESS
To change, for example, the colour,
select
buttons.
Use the Volume up and Volume
down buttons to change the setting.
To save your settings, select STORE
and press the OK button. STORED
will be displayed.
Note:
If you play NTSC formatted tape from the scart,
the TINT menu will appear to adjust the TINT
level.
• Set up Menu
Set up menu is explained above, under "Tuning
the Television" topic
• Features Menu
To reach the feature menu press three times to
MENU button.
a) Sleep Timer
The sleep timer automatically switches the set
to stand-by after the preset time has elapsed.
You can select the time from 15 to 120 minutes
with 15 minutes steps.
There are two ways to set the sleep timer;
8
it using Program down