Expansive Application Software; Windows Related Software; System Configurations; Controlling Ts-590Sg From A Pc Using The Com Connector - Kenwood TS-590SG Manual

08 EXPANSIVE APPLICATION SOFTWARE

8.1 Windows Related Software

This chapter describes the Windows related software to be used to control the TS-590SG from a PC.
Following are the Windows related software products that can be used with the TS-590SG.
Name
ARCP-590G
ARHP-590G
ARVP-10
ARUA-10
Virtual COM Port
Driver

8.2 System Configurations

We will provide some typical system configurations using the TS-590SG and Windows software.

8.2.1 Controlling TS-590SG from a PC using the COM Connector

The microphone connected to the TS-590SG and the transceiver s built-in speaker are used.
Software
Control
ARCP-590G
signal
Audio signal
Table 8-1 Windows Related Software for TS-590SG
This software enables control of the TS-590SG from a PC.
◆ Note that this software cannot be used to control TS-590. To control TS-590, use ARCP-590.
This software is used on the host station PC when the TS-590SG is remotely controlled over a
network. The software is used in combination with ARCP-590G.
◆ Note that this software cannot be used to control TS-590S. To control TS-590S, use ARHP-590.
This VoIP software is to transfer the TX and RX audio signals when remotely controlling the
TS-590SG over a network.
◆ Note that the software is composed of ARVP-10H and ARVP-10R.
This software enables the use of the microphone and speaker of a PC in place of those on the
TS-590SG during USB connection. It enables TS-590SG to transmit the audio signal input to
the PC s microphone via USB audio. And the audio output from the TS-590SG can be output
from the PC s speaker via USB audio.
Note:
◆ If you are using a home-made audio cable connected to the ACC2 connector, this software is
not required.
◆ This software is not required if this is used over a network.
This software when installed on a PC supports the use of ARCP-590G and ARHP-590G after
connecting the TS-590SG to a PC using a USB cable.
Note:
G
◆ If the TS-590S is connected to the PC with an RS-232C cable, this software is not required.
PC
Hardware
-
- -
Description
Type of Connection
* Connected to the COM
RS-232C cable
connector
The microphone connected
to the TS-590SG and
No connection
the transceiver s built-in
speaker
TS-590SG
Hardware
55