Lincoln 2006 Town Car Workshop Manual page 22

Hide thumbs Also See for 2006 Town Car:
Table of Contents

Advertisement

2006 Town Car Workshop Manual
Is the resistance between 250 and 5,500 ohms?
F5 CHECK CIRCUITS 438 (RD/WH), 1123 (YE/WH) AND 1130 (PK/LG) FOR A
SHORT TO VOLTAGE
Ignition ON.
Measure the voltage between ground and:
HVAC module C228a-20, circuit 438 (RD/WH), harness side.
For DTC B1263, HVAC module C228b-15, circuit 1123 (YE/WH), harness
side.
For DTC B1264, HVAC module C228b-14, circuit 1130 (PK/LG), harness
side.
Is any voltage present?
F6 CHECK CIRCUITS 436 (RD/LG), 1123 (YE/WH) AND 1130 (PK/LG) FOR A
SHORT TO GROUND
Ignition OFF.
Measure the resistance between ground and:
HVAC module C228b-8, circuit 436 (RD/LG), harness side.
For DTC B1263, HVAC module C228b-15, circuit 1123 (YE/WH), harness
side.
For DTC B1264, HVAC module C228b-14, circuit 1130 (PK/LG), harness
side.
Is the resistance greater than 10,000 ohms?
F7 CHECK THE DOOR ACTUATOR OPERATION
NOTE: If a jumper fuse opens while carrying out this test step, repair the circuit
(s) for a short.
With the fused jumper connections made as directed below, measure the
resistance between HVAC module C228a-20, circuit 438 (RD/WH), harness side
and HVAC module C228b-15, circuit 1123 (YE/WH), harness side.
Connect a fused jumper wire between:
HVAC module C228a-25, circuit 1380 (TN/YE), harness side and HVAC
module C228b-11, circuit 1566 (RD/YE), harness side.
HVAC module C228a-24, circuit 1379 (PK/LB), harness side and HVAC
module C228a-2, circuit 57 (BK), harness side.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS6G/~MUS~LEN/19/...
Yes
REPAIR circuit 438 (RD/WH), 1123 (YE/WH) or 1130 (PK/LG) for a short to voltage.
CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.
No
GO to F6.
Yes
If diagnosing DTC B1263, GO to F7.
If diagnosing DTC B1264, GO to F8.
No
REPAIR circuits 436 (RD/LG), 1123 (YE/WH) or 1130 (PK/LG) for a short to ground.
CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.
Yes
INSPECT for broken door and linkage. REPAIR as necessary. If no condition is found,
GO to F11.
No
GO to F9.
Page 22 of 45
12/30/2011

Advertisement

Table of Contents
loading

Table of Contents