Disassembly Procedure - Mitsubishi Electric PCA-RP2GA Technical & Service Manual

10

DISASSEMBLY PROCEDURE

PCA-RP3GA
OPERATING PROCEDURE
1. Removing the air intake grille
(1) Slide the intake grille holding knobs (at two locations)
backward to open the intake grill.
(2) When the intake grille left open, push the stoppers on the
rear hinges (at two locations) to pull out the intake grille.
2. Removing the electrical box
(1) Remove the air intake grille.
(2) Remove the screw from the beam and remove the beam.
(3) Remove the screws from the electrical cover, and
remove the electrical cover.
(4) Disconnect CN6V and CN21.
(5) Remove the screws from the electrical box and pull out
the electrical box.
<Electrical parts in the electrical box>
Terminal block (for indoor / outdoor connecting line)
Terminal block (for remote controller)
Fan motor capacitor
Indoor control board
PHOTOS&ILLUSTRATIONS
Figure 1
Intake grill
slide
Intake grill
Holding knobs
Figure 2
Slide to the left
Screw(electrical cover)
Electrical cover
Screw(electrical box)
Photo 1
Fan motor
capacitor
Power board
Indoor
control
board
66
Hinges
Pull out the intake grill
Beam
Clamp
Terminal
block
Terminal
(remote control)
block
(Indoor / outdoor
connecting line)