Brother DCP8080DN Service Update Information page 6

DCP8080DN, DCP8085DN, MFC8480DN, MFC8680DN, MFC8890DW
10. While holding the PE Actuator in place, slide the Separation Roller Drive Shaft to the left far
enough to clear the hole in which the bearing was located. If Side Cover L has not been removed,
the sliding the shaft until it stops against the cover will put it in the correct position.
11. Rotate the PE Actuator down. With the Separation Roller Drive Shaft free of the machine frame
on the right side, the actuator should now be able to move freely enough to return to the correct
position.
NOTE: Be careful not to detach the EG Actuator Spring when performing this step.
EG Actuator
12. Return the Separation Roller Drive Shaft to its original position by sliding it to the right.
13. Reattach the Separation R Shaft Bearing.
14. Reattach the Roller Holder Assembly.
15. Return the machine to its normal upright position.
16. Reinsert the empty paper tray into the machine.
17. Locate the Paper Level Indicator on the front of the tray on the right-hand side and verify that
the blue plastic fills the slot from top to bottom.
"No Paper" Message and Clicking Noise
March 22, 2010
Page 6 of 15
SERVICE
UPDATE No.
F1290