Subaru 2004 Impreza Service Manual page 25

10) Loosen the bolt and nut, and then remove the
bumper beam from body.
C: REPAIR
1. COATING METHOD FOR PP BUMPER
Pro-
cess Process name
No.
1 Bumper mounting
2 Masking
Degreasing, clean-
3
ing
4 Primer paint
5 Drying
Front Bumper
EI-00439
Set the bumper on paint worktable if required.
Use paint worktable conforming to inner shape
of bumper when possible.
Mask specified part (black base) with masking tape. Use masking tape for PP (example, Nichiban
No. 533, etc.).
Clean all parts to be painted with white gasoline, normal alcohol, etc. to remove dirt, oil, fat, etc.
Apply primer one to all parts to be painted, using air gun. Use primer (clear).
Dry at normal temperature [10 to 15 min. at 20°C (68°F)].
In half-dried condition, PP primer paint is dissolved by solvent, e.g. thinner, etc.
Therefore, if dust or dirt must be removed, use ordinary alcohol, etc.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Secure the slider (A) to guide plate (B).
(A)
Tightening torque:
Refer to COMPONENT in General Descrip-
tion.
<Ref. to EI-4, FRONT BUMPER,
COMPONENT, General Description.>
Job contents
(1)
(1) Bumper
(2) Set bumper section
EI-23
EXTERIOR/INTERIOR TRIM
(B)
EI-00521
(2)
EI-00234