Specifications; Manufacturer Declarations; Connection Cable - Sennheiser HDA 300 Instruction Manual

Specifications

Specifications
Frequency response
Transducer principle
Nominal impedance
Characteristic SPL
Max. nominal continuous input
power
Max input voltage
Ear coupling
Contact pressure
Weight (with cable)

Connection cable

Pin assignment of the 6.35 mm jack plug (mono)

Manufacturer declarations

Warranty
Sennheiser GmbH & Co. KG gives a warranty of 24 months on this product.
For the current warranty conditions, please visit our website at
www.sennheiser.com or contact your Sennheiser partner.
FOR AUSTRALIA ONLY
Sennheiser goods come with guarantees that cannot be excluded under the Aus-
tralian Consumer Law. You are entitled to a replacement or refund for a major
failure and compensation for any other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to be
of acceptable quality and the failure does not amount to a major failure. This war-
ranty is in addition to other rights or remedies under law. Nothing in this war-
ranty excludes, limits, or modifies any liability of Sennheiser which is imposed by
law, or limits or modifies any remedy available to the consumer which is granted
by law.
10 | HDA 300
20 – 20,000 Hz
dynamic, closed
23 
117 dB at 1 kHz, 0.5 V
500 mW (in accordance with EN 60268-7)
3.5 V, < 10 min
circumaural
8.8 N ± 0.5 N
approx. 490 g
approx. 2.2 m, single-sided
Red plug = right side of the headphone
1 Audio High (red wire)
2 Audio Low (blue wire)
Blue plug = left side of the headphone
1 Audio High (yellow wire)
2 Audio Low (green wire)