Table of Contents
Advertisement
Reattaching
1. Raising the eject lever on the right, insert the plug-in
board as far as it will go. (The lever on the left can be
tilted.) Finally push in the board while tilting the lever
as shown in the figure so that the board is connected to
the motherboard connector.
n
If the right lever is tilted when inserting the board, the
lever will strike the edge of the upper frame.
2
Route the harness (B) as shown in the figure, and slip
it into the hole of the SY guard. Then twist the excess
harness several times and push it in.
Shielding spring
Harness (B)
Twist and push in
SY guard
DNW-A25WS/A25WSP
1-11. Removing/Reattaching the Plug-in Boards
3. Slip the harness (A) into the hole of the SY guard.
Wrapping the harness (A) around the harness (B)
several times, route it to avoid dotted area in the
figure.
4. Connect the harnesses (A) and (C) to the connectors
on the CN-1662 board (CN2 and CN3).
5. Clamp the harness (A) by the lead pin as shown in the
figure.
6. Fasten the four screws (with stopper) of the battery sub
panel to reattach the battery sub panel to the VTR.
n
Make sure that the harnesses are not on the dotted area
before reattaching the battery sub panel. If the harness-
es are on the dotted area, the panel and boards will
pinch them.
CN2
Battery sub panel
Harness (A)
Board lever
SY guard
Lead pin
Harness (A)
Harness (C)
CN-1662 board
CN2
CN3
Harness (B)
1-13
Advertisement
Table of Contents
