Mounting The Bike Handle - Stihl FS 56 Instruction Manual

English

Mounting the Bike Handle

Mounting the Handlebar
Mount the handlebar on the drive tube
about 10 cm (4 in) forward of the engine
housing.
3
5
4
1
6
Place the handle support (1) on the
N
drive tube (2).
Place the handlebar (3) in the
N
handle support.
Fit the clamp (4) on the handle
N
support. Insert the screws (5)
through the holes in the parts and
screw them into clamp (6) as far as
stop – tighten them only moderately
at this stage.
18
Mounting the Control Handle
3
2
Take out the screw (1) – the nut (2)
N
remains in the control handle (3).
Push the control handle onto the
N
2
handlebar (5) until the holes (6) line
up – the throttle trigger (4) must
point towards the gearbox.
Insert the screw (1) and tighten it
N
down firmly.
4
6
1
5
6
Adjusting and securing the handlebar
A
1
B
Align the handlebar so that
N
distance (A) is about 20 cm (8 in)
and distance (B) about 15 cm (6 in).
Tighten down the screws (1) firmly
N
in a crosswise pattern.
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
FS 56, FS 56 R, FS 56 C, FS 56 RC