Dual XDMA6510 Installation & Owner's Manual page 27

Portable Device Mount Installation
mounting bracket
1. Remove the mounting sleeve.
2. Line up the bracket with the right side of the
head unit as shown above.
3. Insert the supplied screws into the two
mounting holes and tighten.
mounting post
screws
4. Once the bracket is in place, locate the
mounting post.
5. Thread the mounting post by hand, clockwise
into the tab on the bracket.
6. Tighten the mounting post using the supplied
wrench.
mounting bracket
device mount
wrench
7. Remove the plastic nut from the device mount,
and slide it onto the mounting post.
8. Carefully snap the device mount onto the ball
shaped end of the mounting post.
9. Tighten the plastic nut by hand until tight.
Adjust the tension of the cradle using this nut.
plastic nut
mounting bracket
mounting post