The Controls - Hotpoint CH60 ETC Use And Installation Instructions

Switch on the electricity supply to the cooker at the Cooker Control Unit.
Hob Controls
Right Front Control
Main Oven Light
Cooling Fan
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
8

THE CONTROLS

Hob Controls
Dual Circuit Oval
Hotplate control
As each control knob is turned clockwise, numbers from 1 - 6 on the control knob
increase. Setting 6 is the highest/hottest and gives 100% power.
Setting 1 is the lowest/coolest and gives about 7% power.
Variable power is obtainable on each of the heating areas by selecting any number
between 1 & 6.
This is to control a dual circuit oval hotplate with two elements. By turning the knob
clockwise both parts of the hotplate are switched on, numbers 1-4 on the control knob,
4 is the highest setting. With the knob turned anticlockwise, only the inner part of the
hotplate is switched on, this is also indicated by numbers 1-4 on the control knob, 4 is
the highest setting.
Variable power for either the whole or the inner part of the hotplate is obtained by
selecting any number between 1 & 4.
The off position is identified by an '0'.
The hob hot warning lights will operate soon after each of the heating areas have been
switched on. Each warning light will remain illuminated until each heating area has
cooled down.
The main oven light can be switched on, when the oven is not in use, by pressing the
oven light button on the display. The oven light will also operate whenever the main
oven door is opened.
NOTE: The oven light can be switched off when the door is opened by pressing the
oven light button on the display, or by closing the door.
The cooling fan operates with the ovens and grill. The fan will operate at full speed for
a few seconds and then reduce to a lower speed. The cooling fan will only increase to
full speed if the temperature inside the cooker reaches above a certain limit.
Top
Oven
Control
Grill
Control
Main
Oven
Control
Timer