Pop-Up Help - Lowrance M68C IceMachine Installation And Operation Instructions Manual

3. To return to the previous page, press
To change displayed data font size:
1. From the Map or Sonar page, press
2. Press ↓ or ↑ to select Data Type|press → or ← to Data
Size| |
EXIT EXIT
size. (To change the font size for more than one Data Type at the same
time, just follow the above steps, but make all the needed changes be-
fore you press Exit to clear the menu.)
Tip:
If you wish, you can change the font size when you select a data
type for the first time:
1. From the Map or Sonar page, press
| .
D ENT
ATA
2. Press ↓ or ↑ to select Data Type|press → or ← to select Data
Size| .
ENT
The data will be shown in the new font size. To return to the previ-
ous page, press

Pop-up Help

Help is available for virtually all of the menu labels on this unit. By
highlighting a menu item and leaving it highlighted for a few seconds, a
"pop-up" message appears that describes the function of the menu item.
This feature is on by default.
To set up Popup Help: Press
to . With the option highlighted, press
P H
OPUP ELP
on) and uncheck it (turn off.) After the option is set, press
return to the page display.
System Setup Menu, left, with Pop-up Help command highlighted. At
right, this example shows the Pop-up Help message for the Sensitivity
. The selected data type will be displayed in the new
|
EXIT EXIT
command, located on the Sonar Menu.
EXIT
MENU
.
|
MENU MENU
133
| .
EXIT
|↓ to
O
VERLAY
|↓ to
MENU
|↓ to
S
YSTEM
to check it (turn
ENT
| .
D ENT
ATA
O
VERLAY
| |↓
S ENT
ETUP
to
EXIT|EXIT