Configure Dgps - Lowrance GlobalMap 3200 Operation Instructions Manual

For connectors and wiring information for another device, see page 13.
For assistance in configuring the GlobalMap 3200 to communicate with
another device, consult the factory; customer service phone numbers
are in the back of this manual. Also see the entries below for Configure
DGPS and Configure NMEA. To set Com Port Configuration:
1. Press
MENU
2. Press ↓ to
C

Configure DGPS

This unit will recognize Starlink
receivers.
1. Press
MENU
2. Press ↓ to
C
A. If you have a Magnavox receiver, press ↓ to
B. If you have a Lowrance or Starlink receiver, press ↓ to
C. If you have a Magnavox or Starlink, press
the only setup necessary. If you have a Lowrance receiver or another
Magnavox- or Starlink- compatible brand, continue with these steps:
3. Press ↓ to
C
, then use ↑ ↓ → ← to enter the station frequency, then
4. Press
ENT
press .
ENT
5. Press → to
then press
ENT
6. A. If you are not using a Starlink DGPS receiver, press
| |
EXIT EXIT EXIT
B. If you are using a Starlink DGPS receiver, press ↓ to
|press
T M
UNING ODE
vious page.
Menus for changing Com Port settings.
| |↓ to
MENU S
OMMUNICATIONS
| |↓ to
MENU S
OMMUNICATIONS
NMEA
ONFIGURE
then use ↑ ↓ to select the station bit rate,
|
B R ENT
IT ATE
.
| to return to the previous page.
EXIT
|press
ENT
|
S ENT
YSTEM ETUP
| .
P ENT
ORT

, Magnavox
|
S ENT
YSTEM ETUP
| .
P ENT
ORT
|→ to
C
ONFIGURE
| |
EXIT EXIT EXIT
70
.

and Lowrance DGPS
.
|
M ENT
AGNAVOX
S
| |
EXIT EXIT EXIT
| .
DGPS ENT
S
| to return to the pre-
EXIT
.
| .
ENT
TARLINK
. This is
A
TARLINK UTO