Manual Mode - Lopi Horizontal Or Vertical Vent Freestanding Stove Yankee Pellet Stove User Manual

Manual Mode

Manual mode requires the user to turn the
heater on and off manually.
To Start
Press the "Manual Start" button. That's it. The
stove automatically goes to a medium burn rate
and high fan while the igniter starts the fire
burning within 10 minutes. During this period
the lowest "HEAT OUTPUT" light will flash. If
the stove does not start in 30 minutes, the
stove turns off.
Once up to temperature, the stove will then
run at the heat output setting selected on the
control panel (see "To Adjust the Heat" below).
To Shut Down
Move the mode switch to "OFF". The exhaust
blower will still run until the heater cools down.
To Adjust the Heat
Press the "Heat" buttons to adjust the heat
output.
NOTE: During start-up you may adjust the heat
setting. This heat setting will take affect once
the start-up sequence is complete.
Travis Industries
Operation
4050418
AUTO
UP OFF
H
MANUAL
E
A
T
MANUAL
DOWN
START
UP
F
MANUAL
A
N
DOWN
AUGER
TM
TRAVIS INDUSTRIES
HOUSE OF FIRE
AUTO
UP OFF
H
MANUAL
E
A
T
MANUAL
DOWN
UP START
F
MANUAL
A
N
DOWN
AUGER
TM
TRAVIS INDUSTRIES
HOUSE OF FIRE
DISCONNECT POWER BEFORE SERVICE
H
E REMOTE
HIGH
A
AUTO
T
MANUAL
O MED
U
T
AUGER
P
LOW
U
FAULT
T
AUTO
UP OFF
H
MANUAL
E
A
T
MANUAL
DOWN
UP START
F
MANUAL
A
N
DOWN
AUGER
TM
TRAVIS INDUSTRIES
HOUSE OF FIRE
2 1
These lights
indicate the
heat output
setting.
NOTE: the
lights may
be difficult to
see from an
angle.
Press the
"up" or
"down"
button to
adjust the
heat output.
1 0 0 - 0 1 1 5 6