Loading Pellets; The Two Modes Of Operation; Operation (Continued) - Lopi Horizontal Or Vertical Vent Freestanding Stove Yankee Pellet Stove User Manual

2 0

Loading Pellets

Lift the hopper lid to its vertical position. Pour pellets into the hopper until full.
To Open the Hopper Lid:
lift the hopper lid from this
handle.

The Two Modes of Operation:

Manual
Manual mode requires the user to turn
the heater on and off manually.
Auto (requires a thermostat)
Auto mode allows you to use a
thermostat to control room
temperature. The stove automatically
turns on when the temperature drops
below the thermostat setting. Once the
stove reaches operating temperature,
the stove then runs at the heat output
setting selected.
Switching Modes While in
Operation
Whenever the stove is switched from
one mode to another while in
operation, the stove will enter the "start-
up" sequence for a minimum of 20
minutes.
Travis Industries
Operation
To Close the Hopper Lid:
lift the lid, pull this bar forward,
then lower the lid down.
Make sure pellets
are not left on this
heat shield.
Warning:
The front edge of the
hopper lid becomes very
hot, do not touch the area
below the handle.
DISCONNECT POWER BEFORE SERVICE
H
E REMOTE
HIGH
A
AUTO
T
MANUAL
O MED
U
T
AUGER
P
LOW
U
FAULT
T
AUTO
UP OFF
H
MANUAL
E
A
T
MANUAL
DOWN
START
UP
F
MANUAL
A
N
DOWN
AUGER
TM
TRAVIS INDUSTRIES
HOUSE OF FIRE
4050418
These notches allow
you to open the hopper
lid to the level you wish.
NOTE: if using a
modulating remote, this
light will come on to
indicate the remote is
controlling the heater.
These indicator lights
are used to determine
which mode you are in.
Use the mode
switch to
determine the
mode.
1 0 0 - 0 1 1 5 6