Service And Product Maintenance; Troubleshooting - Life Fitness Lifecycle C1 Owner's Manual

SERVICE & PRODUCT MAINTENANCE
6.1 TROUBLESHOOTING
No power.
Clicking noise while pedaling.
Hear noise as speed increases.
Can't feel a resistance change at the
beginning levels.
Wireless heart rate is not working.
Check to see that the power cord is fully plugged into the back of the
Lifecycle exercise bike and into the wall. Make sure the power cord is
fully seated into the back of the Lifecycle exercise bike.
You may be in "Energy Saver Mode". Press the "Energy Saver" button to
see if the console turns on.
Verify that all customer assembly connections are working properly.
Unplug and re-plug each connection to verify. Look to see if any cables
were pinched during assembly.
Use the wrench that was included with the Lifecycle exercise bike to
ensure the pedals are assembled as tight as possible.
It is normal for any mechanical device to become louder as speed
increases.
The resistance curve of the Lifecycle exercise bike is designed so that
you can feel a greater difference in resistance at higher levels.
Potential reasons for the wireless heart rate not to work properly include:
1. The wireless heart rate is turned OFF in the Settings Menu. Enter
the Settings Menu and verify that WIRELESS HR is turned ON.
2. There is poor contact between the telemetry heart rate strap and
the skin.
3. There is electrical interference from electrical appliances with the
telemetry heart rate strap from fluorescent lights, kitchen appliances,
etc. Move the Lifecycle exercise bike to a different location or move
electrical appliances away from the Lifecycle exercise bike.
4. The battery in the Heart Rate Telemetry Strap needs to be replaced.
The battery is a CR2032 (3V).
18