Troy-Bilt Q92KP 60-1880 Operator's Manual page 28

3. Loosen, but do not remove the belt keeper rod on the
pulley located near the back of the deck. See Fig. 7-9.
4. Carefully remove the deck belt from around the three
spindle pulleys and the two deck idler pulleys.
5. On 50" Decks:
To place the new belt, begin by routing the
belt around the two outer spindle pulleys, then around the
front spindle pulley as shown in Fig. 7-11.
6. Then route the belt around the two deck idler pulleys as
shown in Fig. 7-11.
Deck Idler
Pulleys
7. On 46" Decks: To place the new belt begin by routing the
belt around the two outer spindle pulleys as shown in Fig.
7-12.
8. Then route the belt around the two deck idler pulleys as
show in Fig. 7-12.
Deck Idler
Pulleys
9. Reinstall the belt keeper rod loosened earlier.
28 s 7— s
ectiOn ervice
Front Spindle
Pulley
Outer Spindle
Pulleys
Figure 7-11
Outer Spindle
Pulleys
Figure 7-12
CAUTION:
Failure to reinstall the belt keeper rod
may result in serious damage to your tractor's PTO
system.
10. Remount the belt guards removed earlier.
11. Re-install the deck making sure the belt remains routed
around the pulleys as instructed.
12. Pull the right side of the belt and place the narrow V side of
the belt into the PTO pulley. See Fig. 7-13.
Figure 7-13
13. While holding the belt and pulley together, rotate the
pulley to the left. Continue holding and rotating the pulley
and belt until the belt is fully rolled into the PTO pulley.
PTO Belt
Rotate
Pulley