Panasonic VIERA TH-L42ET5A Operating Instructions Manual page 45

Set all channels automatically [Auto Tuning]
Automatically retune all channels received in the area.
1
Start Auto Tuning
Example: Digital TV
Digital TV Auto Tuning
All digital TV tuning data will be erased
● All the previous tuning settings are erased.
● When the operation is completed, the channel at the lowest position will be displayed.
● Search begins in the order from the lower channels to the higher channels.
● If tuning has not been done completely
Set Digital TV channel manually [Manual Tuning]
Normally use [Auto Tuning] or [Update Channel List] to retune Digital TV channels.
If tuning has not been done completely or for adjusting the direction of the aerial or dish, use this function.
●
All channels found will be added to the Channel List.
Digital TV Manual Tuning
Physical Channel [CH21]
Signal Quality 0
0
Signal Strength
No. Channel Name Type
Digital TV: 0
Set Analogue TV channel manually [Manual Tuning]
Set Analogue TV channel manually after Auto Tuning.
●
If a VCR is connected only with the RF cable, select channel position [0].
Analogue TV Manual Tuning
0
Manual Tuning 0
Store
1
Select the channel position
3
Search
[Manual Tuning] (see below)
select physical channel
474.00 MHz
select offset
10
10
New
start tuning
CH 57
75
2
Settings are made automatically
Example: Digital TV
Digital TV Auto Tuning
Scan CH 6
This will take about 3 minutes.
RF Ch Channel Name Type
32 TV Fin land Digital TV
32 Boxer Navigator Digital TV
32 SVT HD Digital TV
Digital TV: 4
Searching
2
Select the channel
4
Select [Store]
select
store
69
Quality
9
9
9
45