Operating Additional Equipment; Connect; Device Connection Wizard - Loewe Connect 32 Operating Instructions Manual

Oper�ting �ddition�l equipment

Device connection wizard

Connecting additional devices to the TV set
The device connection wizard serves for connecting new devices to the
TV set or changing the wiring.
➠ New devices should not be connected until they have
been logged in in the connection wizard.
Call TV menu.
3 4 S elect Connections,
6 go to the menu line below.
3 4 S elect New devices/modifications.
OK Call wizard.
END: It is possible to run the wizard only partially at any
time.
You have to confirm changes on a page with OK.
Connection wizard
Connect the satellite dishes or cable/terrestrial antennas of your AV
equipment (recorder, decoder, ...) to the TV set according to the enclosed
operating manual. The connection wizard assists you when you connect your
equipment to the TV set via the AV sockets AV1, AV2 and AVS or via the
SD/HD-COMPONENT IN or HDMI1/2(DVI)* socket.
Proceed
OK
Follow the instructions on the TV set.
The following illustrations provide an overview of the
possible options.
Connection
Connection wizard
Now the TV set assumes that you have connected the following equipment:
diagram
DVD
AVS AV1
Proceed
OK
The connection diagram shows the devices that are cur-
rently configured. DVD player on AV1 and DVD recorder
on AV2 are factory pre-sets.
END
DVD

AV2 COMP. IN HDMI1 HDMI2
END
AV equipment
Connection wizard
Specify all new AV devices to be connected and all connection changes to the
selection
existing devices here.
New devices/modifications
AV equipment selection
DVD player
DVD
DVD recorder
DVD •
Video recorder
VCR
Satellite receiver
SAT
SetTopBox/dBox
STB
Decoder
Decoder
Camcorder/camera
Camera
Other device(s) to AV1/2/S
AV
Device to COMP.IN
COMP.IN
Device to HDMI1/DVI
HDMI/DVI
Device to HDMI2/DVI
HDMI/DVI
Proceed
OK
Yellow button: Place a check mark after the devices to be
connected.
OK Proceed.
The connection plan is displayed again. Connect the
devices to the back of the TV set (in this example the DVD
player (DVD) to AV1, the DVD recorder (DVD•) to AV2).
Signal type
New devices/modifications
Signal type at socket AV1
Automatic CVBS/YC
CVBS
YC
Proceed
OK
Select the signal type of your set. Leave the setting on
automatic if you are not sure.
Connection
example of a
DVD recorder
ANT2
to a set with
Digital Recorder
DR+
➠ Use EURO AV cable with the right angled plugs.


END
Connect/disconnect
OK
END
TV set
AUDIO
DIGITAL
AV2
IN
DVD recorder
TV
R
Ž
continued on next page
37 -