Intellimute Pro - Cobra XRS 9745 Operating Instructions Manual

Settings
Your Detector
Select/Dim Button
Program/Mute Button
To Set the IntelliMute Activation Point Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to Set
Tone Visual Display Voice
IntelliMute.
None Set IntelliMute None
Press and release the Set/City button Two beeps Press SET
to begin setting IntelliMute RPMs. at desired
RPMs...
Rev your engine to the level you wish to None None
set. Rev the engine slightly above idle and
hold revs steady for two seconds.
At the desired rev level, press and Three beeps IntelliMute
release the Set/City button. Set!
Press and release either the None None
Select/Dim button to proceed to the
next user mode or the Program/Mute
button to exit the Program mode.
Setting IntelliMute RRMs
Set I nte l ... Pre ss S ET.. .
NOTE
If the unit is unable to sense usable pulses within
three seconds or if you do not set a rev point within
20 seconds of beginning these steps, IntelliMute will
indicate an error and automatically turn Off.
IntelliMute
Not Set
Tone Visual Display Voice
In tel l iM u.. .
One beep IntelliMute not set IntelliMute not set
Please try again Please try again Pl ease tr.. .
One beep IntelliMute Off IntelliMute Off
16 English
Settings
Your Detector

IntelliMute Pro

Set/City
Button
IntelliMute Pro prevents detection by radar detector detectors (RDDs) such
as VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is
intended for use by experienced users only.
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
activation point, your detector's radar detection circuits are turned Off to
prevent detection by RDDs.
Before IntelliMute Pro can be turned On, you must have turned On and Set
the IntelliMute activation point. (See pages 14 through 16.)
Set Engine
CAUTION
Revs
When IntelliMute Pro is On, NO radar signals will be detected and
NO alerts will be given at RPMs below the IntelliMute activation point.
None Caution W
To Turn IntelliMute Pro On or Off Using Program Mode
IntelliMute
(See Page 7 For Instructions on Using Program Mode)
Set
In Program mode,
None
go to IntelliMute Pro.
Int el li
Mut e
Set!
IntelliMute Off
Int el li
Mut e
Of f
Tone Visual Display Voice
Two beeps IntelliMute Pro On, IntelliMute Pro On
then i blinks
in the display
One beep IntelliMute Pro IntelliMute Pro Off
Off, then i is
steady in the
display
IntelliMute Pro On IntelliMute Pro Off
Intelli Intelli
Mute Pro
Mute Pro
On Off
NW i h NW i h
Nothing Comes Close to a Cobra ® 17