Intellimute Pro; Voice/Tone Setting; Vg-2 And Spectre I & Iv+ Alert Settings - Cobra XRS 888 Operating Instructions Manual

Settings
Your Detector

IntelliMute Pro

IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as
VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is intended
for use by experienced users only.
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
activation point, your detector's radar detection circuits are turned Off to
prevent detection by RDDs.
Before IntelliMute Pro can be turned On, you must have turned On and Set the
IntelliMute activation point. (See pages 9 through 11.)
CAUTION
When IntelliMute Pro is On, NO radar signals will be detected and
NO alerts will be given at RPMs below the IntelliMute activation point.
To Turn IntelliMute Pro On
While no signal
Tone
is being detected,
Two beeps
press and hold both
the IntelliMute
and City buttons
for four seconds.
To Turn IntelliMute Pro Off
Press and hold both
Tone
the IntelliMute and
One beep
City buttons for
four seconds.
12 English
IntelliMute Button
City Button
Press and hold both
buttons simultaneously
IntelliMute Pro On
c
X K Ka V S
Voice
Visual Display
IntelliMute Pro On c or h will blink
Voice
Visual Display
IntelliMute Pro Off c or h will show
steady
Settings
Your Detector

Voice/Tone Setting

You can set your detector to sound alerts with either a Voice or a Tone. You
can change settings by using the Mute button. In Voice Alert mode, you will
first hear several tones, then a voice message announcing the type of signal
detected, followed by more tones. In Tone Alert mode, you will hear the tones
only. The factory setting
To Change From Voice Alert to Tone Alert
While no signal
Tone
is being detected,
One beep
press and hold
the Mute button
for two seconds.
To Change From Tone Alert Back to Voice Alert
While no signal
Tone
is being detected,
None
press and hold the
Mute button for
two seconds again.
VG-2 and Spectre I & IV+ Alert Settings
Police use radar detector detectors (RDDs) to spot users of radar detectors.
Your detector is able to identify signals from VG-2, Spectre I and Spectre IV+
RDDs and can provide alerts when any of these or similar devices are in use
near your vehicle.
Your detector can be spotted by Spectre IV+ RDDs, but is invisible to VG-2
and Spectre I RDDs. You can choose whether you want to be alerted to VG-2
and Spectre I & IV+ RDD signals. The factory setting for VG-2 and Spectre I &
IV+ alerts is Off.
To Turn VG-2 and Spectre I & IV+ Alerts On and Off
While no signal
Tone
is being detected,
On = Two Beeps
press and hold the
Dim button for
Off = One Beep
four seconds.
Voice
Visual Display
Tone Alert None
Voice
Visual Display
Voice Alert None
Voice Visual Display
V will blink twice
Spectre VG-2 On
in the display
Spectre VG-2 Off V will blink once
in the display
Nothing Comes Close to a Cobra
®
13