Seamless Bypass; Seamless Program Change; Constant Parameters - Vox DelayLab Owner's Manual

Analog bypass
Use this to output only the sounds that bypass through the
analog circuit, but not through DSP, A/D or D/A.
1.
Press and hold the WRITE button and Channel switch C
and connect a cable to the INPUT (L/MONO) jack.
TIP: The DSP bypass is set as the factory default.

Seamless bypass

When bypass is set, you can switch the bypass sound while
the reverberant sound remains.
Switch the setting as described below.
Seamless bypass is enabled as the factory default.
Enabling seamless bypass
Press and hold the WRITE button and Channel switch B and
connect a cable to the INPUT (L/MONO) jack.
Disabling seamless bypass
Press and hold the CANCEL button and Channel switch B
and connect a cable to the INPUT (L/MONO) jack.

Seamless Program Change

When switching programs, you can switch the following
programs while the reverberant sound remains.
Seamless Program Change is enabled as the factory
default.
Switch the setting as described below.
Enabling Seamless Program Change
Press and hold the WRITE button and Channel switch A and
connect a cable to the INPUT (L/MONO) jack.
Disabling Seamless Program Change
Press and hold the CANCEL button and Channel switch A
and connect a cable to the INPUT (L/MONO) jack.

Constant Parameters

This function leaves the TIME, FEEDBACK and MIX values
of the Effect Type before they are changed when the Effect
Type is changed by the Type Selector.
The Constant Parameters feature is disabled as the
factory default.
Switch the setting as described below.
Enabling Constant Parameters
Press and hold the CATEGORY button and Channel switch
A and connect a cable to the INPUT (L/MONO) jack.
Disabling Constant Parameters
Press and hold the FINE button and Channel switch A and
connect a cable to the INPUT (L/MONO) jack.
13