Environmental Protection - Ryobi EBS800 Original Instructions Manual

LUBRICATION
All of the bearings in the product are lubricated with a
suffi cient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.
CLEANING THE SANDING BELT
The sanding belt that came with your sander is made to
be re-used. Therefore, it is important that it be cleaned
periodically to remove sanding residue and foreign material
that can accumulate over time. One of the ways to clean
sanding belt is to rub the sheets with a hard rubber block.
You can also use the clean rubber sole of a shoe.
Always remove the sanding belt from sander before
cleaning. Failure to do so could cause serious personal
injury.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS
Safety Alert
V Volts
Hz Hertz
Alternating current
W Watts
n No-load speed
o
min‫¹־‬ Revolutions or reciprocations per minute
Regulatory Compliance Mark (RCM). Product
meets applicable regulatory requirements.
Double insulation
Please read the instructions carefully before
starting the product.
Wear ear protection
Wear eye protection
WARNING
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
Safety
3