Foxconn P4M800P7MA series User Manual page 51

vSuspend Mode
This option is used to set the idle time before the system enters into sleep
status. The setting values are: Disabled, 1 Min, 2 Min, 4 Min, 6 Min, 8 Min, 12
Min, 20 Min, 30 Min, 40 Min, 1 Hour.
vVideo Off Option
This option is used to set video off option. The setting values are: Always On,
Suspend -> Off.
vVideo Off Method
This option is used to define the video off method. "Blank Screen" mode
means that after the computer enters into power saving mode, only the monitor
will close, however, the vertical and horizontal scanning movement of the screen
continues. When you select the "V/H SYNC + Blank" mode the vertical and horizon-
tal scanning movement of screen stops when the computer enters power
saving mode. "DPMS Support" mode is a new screen power management
system, and it needs to be supported by the monitor you're using.
vMODEM Use IRQ
This option is used to set the IRQ in which the modem can use. The setting
values are: NA, 3, 4, 5, 7, 9, 10, 11.
vSoft-Off by PWRBTN
This option is used to set the power down method. This function is only valid
for systems using an ATX power supply.
W hen "Instant-Off" is selected, press the power switch to immediately turn
off power.
W hen "Delay 4 Sec" is selected, press and hold the power button for four
seconds to turn off power.
vRun VGABIOS if S3 Resume
This option allows the system to initialize the VGABIOS from S3 (Suspend to
RAM) sleep state. The available setting values are: Auto, Yes and No.
vAc Loss Auto Restart
The system will switch which status when power comes back after a power
failure. The setting values are: Auto, On, Off.
IRQ/Event Activity Detect
v
Press Enter to set IRQ/Event Activity Detect.
Chapter 3 BIOS Description
43